Bridge and tower options for Heretic Cruisers and Battleships. Pre-Imperial and Pegasus bridges will not fit on Battleship tower platforms unless they are extensively modified. The standard Battleship tower platform is 0.8cm x 0.8cm wide. Please check additional information tab for Bridge/Tower sizes (unit: Centimetre)
30% discount for the scratchbuilders full package composed of x28+ individual components
| Weight | 0.002 kg |
|---|---|
| Dimensions | 1 × 1 cm |
| Bridge Options | [00] Full Package, [01] Pre-Imperial Half Bridge, [02] Pre-Imperial Full Bridge, [03] Turret Platform x2, [04] Nagato, [05] Eagle Gun, [06] Flakturm Tower, [07] Dome M, [08] Pipe Organ, [09] Box Organ, [10] Brazier, [11] Spinal Gun S, [12] Pegasus Half-Bridge, [13] Pegasus Full Bridge, [14] Mech Tower, [15] Bridge M, [16] Spinal Gun M, [17] Chimera Bridge, [18] Asymmetric Crane Bridge, [19] Catapult x2, [20] Cyclops Full Bridge, [21] Tsar Bridge, [22] Legacy Bridge, [23] KGV, [24] Marine Pagoda |
Manufacturer:
Manufacturer in the sense of the General Product Safety Regulation (GPSR): Battlefleet Galaxy
Manufacturer address: Unit 4, 9 Crossley Street, Halifax, HX1 1UG, United Kingdom
Manufacturer email: support@battlefleetgalaxy.com
EU Representative (GPSR):
EU representative for the General Product Safety Regulation (GPSR): Simon Saier
EU representative address: Bichler Str. 4a, 82377 Penzberg, Germany
EU representative email: eu@battlefleetgalaxy.com
This is a 3D printed product made of UV hardened resin. Models are cleaned and completely cured with UV light.
Before printing, a support structure needs to be added to the models, these are normally removed after printing, but leave “scars” on the model. These are production-related and do not represent a defect in the product.
Support structure might still remain on the model and can be removed with a sharp hobby knife.
Resin dust is a health hazard if inhaled into the lungs. Grinding and filing is not recommended. Otherwise, such work should only be carried out with appropriate protective equipment (fine dust mask) and/or wet sandpaper.
It’s possible that the models are hollow. In this case, the model has drainage holes through which the liquid resin could leak out. The inside of the model was then also cured. Drainage holes can be closed with modelling putty.
Resin heat-sensitive and can therefore deform during the printing process, during the removal of the support structures or during curing. Hot water or a heat gun/hair dryer can quickly remedy this. The affected part is heated and then carefully bent into the correct position.
Important notice
Warning! Not for children under the age of 3. Choking hazard due to small parts.
This product is not a toy.
