Warning: by adding this product to the cart and agreeing to the Terms & Conditions on checkout, you acknowledge the following: Compatible repair parts are sold for the exclusive use of repairing damaged GW ships, so as to restore its original appearance. These parts are manufactured in UV cured resin, as opposed to the white metal used in the originals. Battlefleet Galaxy has no affiliation with Games Workshop, and these parts should be considered non-OEM, or aftermarket parts for repair.
You must abide by these restrictions and only use the Goods for their intended purpose (ie. repairing an original GW battleship). We may cancel/refund part of your order if there is reason to believe you may not use the repair parts for their intended purpose of repair (ie. enquiring if the repair part fits another range of third party ships).
They are not the product of 3D scans, and neither are they 1:1 replicas. Some design elements have been modified and reinterpreted (e.g. addition of the forward vents in the Cruiser Wing Sail).
Each wing comes as a left & right pair.
Margin of error for measurements are ±0.2cm (0.08″)
Manufacturer:
Manufacturer in the sense of the General Product Safety Regulation (GPSR): Battlefleet Galaxy
Manufacturer address: Unit 4, 9 Crossley Street, Halifax, HX1 1UG, United Kingdom
Manufacturer email:Â support@battlefleetgalaxy.com
EU Representative (GPSR):
EU representative for the General Product Safety Regulation (GPSR): Simon Saier
EU representative address: Bichler Str. 4a, 82377 Penzberg, Germany
EU representative email: eu@battlefleetgalaxy.com
This is a 3D printed product made of UV hardened resin. Models are cleaned and completely cured with UV light.
Before printing, a support structure needs to be added to the models, these are normally removed after printing, but leave “scars” on the model. These are production-related and do not represent a defect in the product.
Support structure might still remain on the model and can be removed with a sharp hobby knife.
Resin dust is a health hazard if inhaled into the lungs. Grinding and filing is not recommended. Otherwise, such work should only be carried out with appropriate protective equipment (fine dust mask) and/or wet sandpaper.
It’s possible that the models are hollow. In this case, the model has drainage holes through which the liquid resin could leak out. The inside of the model was then also cured. Drainage holes can be closed with modelling putty.
Resin heat-sensitive and can therefore deform during the printing process, during the removal of the support structures or during curing. Hot water or a heat gun/hair dryer can quickly remedy this. The affected part is heated and then carefully bent into the correct position.
Important notice
Warning! Not for children under the age of 3. Choking hazard due to small parts.
This product is not a toy.
