Accessories, Kitbash Parts

Keel and Rudders

Name: Keel and Rudders
SKU: ACA121
Availability: InStock

£0.80 – £4.70

Category

Size

Clear

SKU: ACA121 Categories: Accessories, Kitbash Parts

Approximate Sizes for Rudder/Fins:

Large: length 30mm, height 20mm
Medium: length 23mm, height 16mm
Super Small: length 15mm, height 10mm
- Please note there are no small size rudders, only super small.
- This is because medium rudders are used in places where you would typically find small size items, such as the M5 Light Cruiser
- The super small size rudder is only appropriate for frigates (M6 class)

Can be shipped in Large Envelope

Category	[01] Marine Rudder, [02] Standard Rudder, [03] Crusader Rudder, [04] Heretic Keel V1, [05] Imperial Keel V1, [06] Heretic Keel V2, [07] Imperial Keel V2, [08] Parapet Wing Tower, [09] Missile Pod, [10] Fin Rudder Weapon Bay
Size	Large, Medium, Super Small (SS)

Manufacturer:
Manufacturer in the sense of the General Product Safety Regulation (GPSR): Battlefleet Galaxy
Manufacturer address: Unit 4, 9 Crossley Street, Halifax, HX1 1UG, United Kingdom
Manufacturer email: support@battlefleetgalaxy.com

EU Representative (GPSR):
EU representative for the General Product Safety Regulation (GPSR): Simon Saier
EU representative address: Bichler Str. 4a, 82377 Penzberg, Germany
EU representative email: eu@battlefleetgalaxy.com

This is a 3D printed product made of UV hardened resin. Models are cleaned and completely cured with UV light.

Before printing, a support structure needs to be added to the models, these are normally removed after printing, but leave “scars” on the model. These are production-related and do not represent a defect in the product.
Support structure might still remain on the model and can be removed with a sharp hobby knife.

Resin dust is a health hazard if inhaled into the lungs. Grinding and filing is not recommended. Otherwise, such work should only be carried out with appropriate protective equipment (fine dust mask) and/or wet sandpaper.

It’s possible that the models are hollow. In this case, the model has drainage holes through which the liquid resin could leak out. The inside of the model was then also cured. Drainage holes can be closed with modelling putty.

Resin heat-sensitive and can therefore deform during the printing process, during the removal of the support structures or during curing. Hot water or a heat gun/hair dryer can quickly remedy this. The affected part is heated and then carefully bent into the correct position.

Important notice
Warning! Not for children under the age of 3. Choking hazard due to small parts.
This product is not a toy.