Can be shipped in [Large Envelope]
[Coupon Discounts are not applicable to this product category]
You can download this for FREE on Thingiverse.
I apologise for the high price, I really need a vacuum chamber and resin casting gear to bring down the cost of production.
1 x 60mm flight stand (60mm/35mm stem option available)
- Two 5mm dia x 2mm thick N35 neodymium magnets included
- Suitable for M1, M2, M3 class ships
- Ships with heavy prows like Marine/Crusader will require weights in the rear to correctly balance.
- 60mm/35mm tall
1x 32mm flight stands
- Two 3mm dia x 2mm N35 neodymium magnets included
- Suitable for ships in the class M4, M5, M6
- Does not fit ships smaller than a frigate because magnet is wider than ship body
- Ships with heavy prows like Marine/Crusader will require weights in the rear to correctly balance.
- 30mm tall
1 x 60mm Official Citadel flight stand
- Two stems (30/35mm long included)
- Suitable for M1, M2, M3 class ships
- I strongly recommend you purchase from Games Workshop if you intend to purchase any more than 2
1 x 32mm Troublemaker Games flight stand
- One stem (32mm long included)
- Suitable for M4, M5, M6 class ships
- I strongly recommend you purchase direct from Troublemaker Games if you intend to purchase any more than 5
1 x 20mm Square Base with diagonal slot
- One insert with x7 pre drilled holes
- 4cm of 0.3mm steel wire
- Suitable for ordnance markers
Citadel Flying Bases
Material: Acrylic
Manufacturer:
Games Workshop Limited
Willow Road, Nottingham, NG7 2WS, UK
EU Representative (GPSR):
Games Workshop Limited – Irish branch
Unit 3, Lower Liffey Street,
Dublin 1, D01 K199, Ireland
Magnetized Flight Stands
Material: UV hardened Resin, Neodymium Magnets
Manufacturer:
Manufacturer in the sense of the General Product Safety Regulation (GPSR): Battlefleet Galaxy
Manufacturer address: Unit 4, 9 Crossley Street, Halifax, HX1 1UG, United Kingdom
Manufacturer email: support@battlefleetgalaxy.com
EU Representative (GPSR):
EU representative for the General Product Safety Regulation (GPSR): Simon Saier
EU representative address: Bichler Str. 4a, 82377 Penzberg, Germany
EU representative email: eu@battlefleetgalaxy.com
Neodymium Magnets in magnetized flight stands: These magnets can crush your fingers if handled incorrectly.
This is a 3D printed product made of UV hardened resin. Models are cleaned and completely cured with UV light.
Before printing, a support structure needs to be added to the models, these are normally removed after printing, but leave “scars” on the model. These are production-related and do not represent a defect in the product.
Support structure might still remain on the model and can be removed with a sharp hobby knife.
Resin dust is a health hazard if inhaled into the lungs. Grinding and filing is not recommended. Otherwise, such work should only be carried out with appropriate protective equipment (fine dust mask) and/or wet sandpaper.
It’s possible that the models are hollow. In this case, the model has drainage holes through which the liquid resin could leak out. The inside of the model was then also cured. Drainage holes can be closed with modelling putty.
Resin heat-sensitive and can therefore deform during the printing process, during the removal of the support structures or during curing. Hot water or a heat gun/hair dryer can quickly remedy this. The affected part is heated and then carefully bent into the correct position.
Important notice
Warning! Not for children under the age of 3. Choking hazard due to small parts.
This product is not a toy.
