- Elastic – our fine rigging thread made of lycra won’t snap or damage your model if you accidentally touch it.
- Add extra detail to your models
- Supplied in loose 50cm threads
- Enough to rig 1~2 battleships or 2~3 cruisers
Nearly all our ships support rigging, you can check for the term “ready for rigging” on their product pages.
Can be shipped in [Large Envelope]
This product is for people who are unsure about rigging and want to dip their toes in.
It is a very frustrating experience and requires a steady hand, good lighting, $30 high-end tweezers and the Emperor’s blessing to pull off cleanly.
If you want to buy in bulk, I recommend ‘Infini Models – 40 Denier Super Fine Rigging [£15]’ to rig your whole fleet.
I am aware Ammo/MIG also produce rigging but their smallest size (0.01mm) is nearly twice the thickness of the ones I use and I do not recommend it for this scale.
Manufacturer:
Mig Jimenez, S.L.
Polígono Industrial Miguel de Eguía, Calle Zarapuz, 3
31200 Estella, Navarra
Spain
Telephone: (+34) 948 552 882
Email: info@ammo.es
This is a 3D printed product made of UV hardened resin. Models are cleaned and completely cured with UV light.
Before printing, a support structure needs to be added to the models, these are normally removed after printing, but leave “scars” on the model. These are production-related and do not represent a defect in the product.
Support structure might still remain on the model and can be removed with a sharp hobby knife.
Resin dust is a health hazard if inhaled into the lungs. Grinding and filing is not recommended. Otherwise, such work should only be carried out with appropriate protective equipment (fine dust mask) and/or wet sandpaper.
It’s possible that the models are hollow. In this case, the model has drainage holes through which the liquid resin could leak out. The inside of the model was then also cured. Drainage holes can be closed with modelling putty.
Resin heat-sensitive and can therefore deform during the printing process, during the removal of the support structures or during curing. Hot water or a heat gun/hair dryer can quickly remedy this. The affected part is heated and then carefully bent into the correct position.
Important notice
Warning! Not for children under the age of 3. Choking hazard due to small parts.
This product is not a toy.
